ESP32-S2-WROOM and ESP32-S2-WROOM-I are two powerful, generic Wi-Fi MCU modules that have a rich set of peripherals. They are an ideal choice for a wide variety of application scenarios relating to the Internet of Things (IoT), wearable electronics and smart home.
The basis of these modules is ESP32-S2, an Xtensa® 32-bit LX7 CPU that operates at up to 240 MHz. The chip has a low-power co-processor that can be used instead of the CPU to save power while performing tasks that do not require much computing power, such as monitoring of peripherals.
ESP32-S2 integrates a rich set of peripherals, ranging from SPI, I²S, UART, I²C, LED PWM, LCD, Camera interface, ADC, DAC, touch sensor, temperature sensor, as well as up to 43 GPIOs. It also includes a full-speed USB On-The-Go (OTG) interface to enable USB communication.
ESP32-S2-WROOM comes with a PCB antenna and ESP32-S2-WROOM-I with an IPEX antenna. They both feature a 4 MB external SPI flash.
Main Features:
MCU
- ESP32-S2 embedded, Xtensa® single-core 32-bit LX7 microprocessor, up to 240 MHz • 128 KB ROM
- 320 KB SRAM
- 16 KB SRAM in RTC
Wi-Fi
- 802.11 b/g/n
- Bit rate: 802.11n up to 150 Mbps
- A-MPDU and A-MSDU aggregation
- 0.4 µs guard interval support
- Center frequency range of operating channel: 2412 ~ 2484 MHz
Hardware
- Interfaces: GPIO, SPI, LCD, UART, I2C, I2S, Camera interface, IR, pulse counter, LED PWM, USB OTG 1.1, ADC, DAC, touch sensor, temperature sensor
- 40 MHz crystal oscillator
- 4 MB SPI flash
- Operating voltage/Power supply: 3.0 ~ 3.6 V
- Operating temperature range: –40 ~ 85°C
- Dimensions: (18 × 31 × 3.3) mm
Certification
- Green certification: RoHS/REACH
- RF certification: FCC/CE-RED/SRRC Test
- HTOL/HTSL/uHAST/TCT/ESD
Check the ESP32-S2-WROOM and ESP32-S2-WROOM-I wifi modules in online range products of SOS electronic.
For more information about Espressif products, do not hesitate to contact SOS electronic at [email protected]
